Home >> Injectable >> Injectable Pump & Valve Sealant

Injectable Pump & Valve Sealant

Mechanical Seals and Gasket Supply is our Specialty. American Seal and Packing is a leading manufacturer & distributor of mechanical seals, Grafoil, gasket material, cut gaskets and quality o-rings providing innovative solutions to mechanical seal problems. We're finding better ways to serve our customers all the time. In addition to our expanding line of industrial mechanical seals, we're updating and upgrading this web site to provide you more information about our company and our products.

Injectable Pump Packing

20  [Order-On-Line]

A blend of exfoliated graphite particles and high-temperature sacrificial lubricants in this injectable packing for extreme temperature service applications.

Available In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb

25 [Order-On-Line]

A high-performance, chemically resistant product with bearing pellets in this injectable packing. Ideal for higher pressure the toughest applications.

 Available In:

2.2 lb
11 lb
22 lb

26 [Order-On-Line]

A non-straining, non-toxic fiber blended with FDA-approved lubricants in this injectable packing for clean or food grade applications.

 Available In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb


27 [Order-On-Line]

A blend of high-performance fibers and chemically resistant lubricants make this injectable packing ideal in a wide range of applications including: chemical, and waste water.

 Available In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb

29 [Order-On-Line]

A blend of synthetic fibers and non-straining lubricants for general service & pulp and paper

 Available In:
10-pack stick cartridges
2.2 lb
11 lb
22 lb
 

An Easy and Convenient Product to Use

Injectable packings are easy to install. The initial installation of injectable packing materials is done by hand. Tightening the gland nut compresses the packing and forces it to conform to any irregular spaces caused by wear. An anti-extrusion ring composed of suitably sized braided packing material is set at the top and bottom of the stuffing box or packing gland to prevent the injectable packing from being forced out when pressure is applied.

The injection gun

The injection gun utilizes a button-head or flow-through fitting permanently installed on the pump or valve stuffing box.

Since it requires no electricity, the injection gun can be used anywhere to replenish packing easily and conveniently. The all-steel hydraulic gun is completely portable and is very easy to use.

The valve or pump stuffing box fitting allows the injectable packing to be hand-injected into the shaft stuffing box using the injector gun. No downtime is required for the repacking operation since the equipment can continue to run during the repacking operation.

How to use the injectable packing gun

To properly replenish the packing material, the stuffing box fitting must be located. Next, the injection gun is coupled to the fitting.

When the gun is properly coupled to the fitting, the on-off handle on the fitting is turned to the open position and the new packng is pumped into the fitting until the required amount of injectable packing is injected.

When the operation is complete, the fitting handle is placed in the off position and the gun is disconnected from the stuffing box fitting. Remember to properly disassemble and return your injection gun to its container where it may be stored until needed again.

Note: Button-head fittings with check ball valve do not required ball valve for on-line repacking.


Call us at: 714-361-1435   Fax: 714-593-9701

Our Select Manufacturers

  • Flow Serve
  • Borg Warner
  • Durametallic
  • AST

Our Select Manufacturers

  • JM Clipper
  • Graftech
  • Lamons
  • Vulcan

Contact

  • Call us at: 714-361-1435
  • Fax: 714-593-9701